Subaru LEGACY 2003 Service Manual page 24

VDC (DIAGNOSTICS)
3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select {2.
Each System Check} and press the «YES» key.
2) On the «System Select Menu» display screen,
select {Brake System} and press the «YES» key.
3) Press the «YES» key after the engine type is dis-
played.
4. FUNCTION CHECK
Display screen
ABS sequence control mode
VDC check mode
Set mode St. r. A. Sen. N &
Lat. G Sen. Op
SUBARU SELECT MONITOR
Contents to be monitored
Perform ABS sequence control by operating
valve and pump motor sequentially.
Perform VDC sequence control by operating
valve and pump motor sequentially.
Set both the neutral position of the steering
angle sensor and the zero "0" point of the lateral
G sensor.
VDC-22
4) On the «Brake Control Diagnosis» display
screen, select {Clear Memory} and press the
«YES» key.
5) When `Done' and `turn ignition switch OFF' are
shown on the display screen, turn the Subaru Se-
lect Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUB-
ARU SELECT MONITOR OPERATION MANUAL.
<Ref. to VDC-16, ABS Sequence Control.>
<Ref. to VDC-19, VDC Sequence Control.>
<Ref. to VDC-26, Steering Angle Sensor.>
Index No.