How To Contact Fluke Calibration - Fluke 6050H User Manual

Calibration bath

Hide thumbs Also See for 6050H:

User manual (65 pages)

Table Of Contents

Table of Contents

•

This bath is not designed to be portable. Therefore, moving

the bath once it has been installed should be kept to a

minimum. NEVER MOVE A BATH THAT IS FULL OF "HOT"

FLUID. This action could be extremely dangerous and could

result in personal injury to the person moving the bath. If the

bath is going to be placed in an area where it may need to be

moved frequently, Fluke Calibration sells a special cart

designed to accommodate the bath. However, even with a cart

the bath should not be moved full of "hot" fluid. The fluid can

splash causing injury or if the bath and cart tip, the "hot" fluid

could cause damage to the surrounding area and personnel.

•

If the bath must be moved, allow the salt to solidify and cool.

Care must be used when moving the bath with the fluid

solidified in the bath. The control probe can easily be

damaged. Two people are required to safely move the bath.

One person should lift the bath by the tower, while the second

person lifts from underneath the bath tank.

•

The control probe must be inserted through the lid into the

bath fluid and plugged into the socket at the back of the bath.

DO NOT operate the bath without the control probe properly

inserted and attached. The bath will not operate correctly

without the control probe. Injury to operating personnel and

permanent damage to the bath could occur.