Firmware Upgrade - Telos Zephyr IPORT PLUS User Manual

INTRODUCTION

Firmware Upgrade

This is on the System page.
You might receive this via email from our support department, or you might find it on our website. To install new
firmware, the first step is to download it to your PC. Then browse to locate it, then click the Upload button to install
it into the iPort.
To ensure a smooth upgrade, this procedure must be strictly followed. New firmware can only be uploaded to Bank
1, after switching the operation to Bank 0.
If the upload is started, but does not succeed, Bank 1 will become unusable, and you will continue on Bank 0 which
is working. You can attempt to upload to Bank 1 any number of times, and you can still reboot from Bank 0.
In case booting starts from a corrupted bank and does not succeed, after the third unsuccessful attempt the
bootloader would automatically switch the system to using the other bank.
When the firmware has been successfully uploaded, click the Apply Selected Bank button to activate it.
The Zephyr iPort PLUS will be offline for 2 to 4 minutes while the firmware updates.
To Learn More
The TelosAlliance.com website has a wealth of information on Livewire technology, the wide range of Live-
wire-equipped gear and partners, as well as information on MPEG codecs, networks, IP streaming, etc.
Our support team is standing-by 24/7 to answer your specific questions. In the USA, contact +1 216 241.7225.
Worldwide, email support@TelosAlliance.com.
What's Next?
We've just covered the nuts and bolts of getting Zephyr iPort PLUS installed and connected to the network, and
discussed how to update and maintain its firmware. You also learned how to set up your unit's configuration files.
Since the main function of Zephyr iPort PLUS is sending high-quality audio from point A to point B, we'll next
discuss how to do that with the MPEG or optional aptX® Enhanced encoders.
SECTION 1 |
6