Konica Minolta MAGICOLOR 3300 Service Manual page 59

Removal
1) Remove the CASSETTE of the TRAY 2. (RRP1.1)
2) Remove the COVER FRONT. (RRP1.1)
3) Remove the COVER R (PL15.2.2). (RRP1.2)
4) Remove the COVER L (PL15.2.1). (RRP1.3)
5) Remove the CHUTE ASSY TURN (PL153.7). (RRP1.4)
6) Remove the COVER CST SLIDE (PL15.3.8). (RRP1.6)
7) Remove the HARNESS ASSY FDR2T (grey) (LP15.5.3). (RRP1.5)
8) Remove the DRIVE ASSY FEEDER SINGLE (PL15.5.5). (RRP1.7)
9) Remove the INDICATOR ASSY (PL15.5.8). (RRP1.8)
10) Remove the BRACKET LOW PAPER . (RRP1.11)
11) Remove the PWBA OPTFDR (PL15.5.1). (RRP1.10)
12) Remove the GUIDE ASSY CASSETTE R (PL15.3.2). (RRP1.11)
13) Remove the GUIDE ASSY CASSETTE L (PL15.3.1). (RRP1.12)
14) Remove the LINK ACTUATOR (PL15.4.6). (RRP1.13)
15) Remove 2 screws securing the PICK UP ASSY TR2 (PL15.4.1) to the right side of the OPTION
FEEDER frame.
16) Remove 2 claws of the PICK UP ASSY TR2 (PL15.4.1) and tip of the ROLL ASSY TURN (PL15.4.20)
from the 2 slits and window of the OPTION FEEDER left side frame.
17) Remove the PICK UP ASSY TR2 (PL15.4.1) through the window, avoiding the interference with the
OPTION FEEDER frame.
When removing the screws, be careful not to damage the GEAR or SPRING with the
screwdriver. When passing the PICK UP ASSY TR2 (PL15.4.1) through the window of
the OPTION FEEDER frame, be careful not to damage the rubber parts.
Replacement
Replace the components in the reverse order of removal.
When replacing the screws, be careful not to damage the GEAR or SPRING with the
screwdriver. When passing the PICK UP ASSY TR2 (PL15.4.1) through the window of
the OPTION FEEDER frame, be careful not to damage the rubber parts.
Chapter 3 Removal and Replacement Procedures
3-59