Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(8) Disc Cover (Figs. 5-3-9, 5-3-10)
1) Remove four screws [X] and pull up the parts (m) of accessory shoe. After work, reinstall part
[m] and screws [X] to the accessory shoe: The accessory shoe is set as a service part, including
part [m] and screws [X].
2) Move the lock arm (b) in the direction of the arrow to open the disc cover (a).
3) Open the card slot cover (c).
4) Disconnect the flat cable (e) from MAN circuit board (d).
5) Remove four screws [D].
6) Remove the disc cover in the direction of the arrow: Be careful not to damage the flat cable (e)
that extends from the disc cover.
Procedure and caution for reassembly
1) Reinstall the disc cover so that the hinge
cover. (Fig. 5-3-10)
2) Pass the flat cable (e) extending from the disc cover through the gap between frame (g) and R
case (h), and then connect it to the MAN circuit board (d). (Fig. 5-3-10)
1 [x]
(a)
3
(c)
4-2
Fig. 5-3-9 Disc Cover
[D] M1.6×2.5 (Black)
[X] M2×2.5 (Black)
1
(m)
(n)
(b)
(d)
2
4
4-1
(d)
(e)
of R case fits into portion
(f)
(k)
(g)
(j)
(f)
(a)
(h)
Fig. 5-3-10 Disc Cover
5 - 8
at the inside top of disc
2
(a) Disc Cover
(b) Lock Arm
(c) Card Slot Cover
(d) MAN Circuit Board
(e) Flat Cable
(f) Hinge of R Case
(g) Frame
(h) R Case
(j) Disc Drive Unit
(k) Loader
(m)Parts of Accessory Shoe
(n) Accessory shoe
2
1
6
(a)
(c)
(e)
5 [D]
5 [D]
Advertisement
Table of Contents
