Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(11) AEL and MAN Circuit Boards (Fig. 5-3-13)
1) Disconnect the flat cable from AEL circuit board (a).
2) Disconnect the SHE circuit board (c) in the direction of the arrow from the AEL circuit board.
3) Disconnect the DRF circuit board (d) in the direction of the arrow from the MAN circuit board.
4) Disconnect the four flat cables from MAN circuit board (b).
5) Remove three screws [G].
6) Remove the AEL circuit board assembled with MAN circuit board in the direction of the arrow
from the R block (e).
7) Remove the AEL circuit board in the direction of the arrow to disconnect it from MAN circuit
board.
Procedure and caution for reassembly
Be sure to attach the heat sink rubber (f) when installing the MAN circuit board: Forgetting to
attach the heat sink rubber could cause a fault.
(a) AEL Circuit Board
(b) MAN Circuit Board
(c) SHE Circuit Board
(d) DRF Circuit Board
(e) R Block
(f) Heat Sink Rubber
[G] M1.7×3 (Gold)
(c)
(e)
2
(f)
(b)
4-1
4-2
1-1
1-2
Fig. 5-3-13 AEL and MAN Circuit Boards
(d)
3
4
5 [G]
4
6
1
7
5 [G]
5 - 11
(a)
5 [G]
Advertisement
Table of Contents
