Sony BVP-900P Maintenance Manual page 35

Display descriptions
Marks Board/Block
1
AD-148
2
PR-237
3
DA-128
4
MS-57
5
MD-83
6
AU-250
7
PANEL
8
OHB
9
RC-68 *1
!/
CCU *2
!-
*3
RM
!=
—
*1: The RC-68 board is supplied with the OHB-730WS/730WSP/750WSA/750WSAP.
When the RC-68 board is not installed in the camera, the column 9 is not displayed.
*2: When the CCU is not connected to the camera, the column !/ is not displayed.
*3: When the RM is not connected to the camera, "NC" is displayed in the column !-.
BVP-900 P1
Judging point
The serial data is correctly received from the AT-120 board.
There is no problem when IC8, IC24 and IC33 run diagnostics on themselves.
The serial data is correctly received from the AT-120 board.
A multiplex sync signal is output to the viewfinder.
An RF signal is output to the TRIAX connector.
The level of AUDIO RF signal exceeds the standard level.
Communication with the AT-73 board (rear panel) is normal.
The serial data is correctly received from the AT-120 board.
There is no problem when IC1 to IC3 run diagnostics on themselves.
The serial data is correctly received from the CCU.
The serial data is correctly received from the RM.
A power-on time of the camera is displayed. (Unit:Hour)
2-4. Self-Diagnosis
2-5 (E)