Instrument and control functions
Turn signal switch "
To signal a right-hand turn, push this
switch to "
". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
4
Horn switch "
"
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
EAU12461
/
"
Hazard switch " " (XVS650AH)
With the key in the "ON" or "
tion, use this switch to turn on the haz-
". When
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12501
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12662
/
"
gine not running, otherwise the bat-
" before starting
tery may discharge.
" to
EAU12713
EAU12735
Clutch lever
" posi-
ECA10062
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
4-18.)
4-7
EAU12822