Yamaha XVS650H 2016 Owner's Manual page 79

4. Remove the brake pedal free play
adjusting nut, and then discon-
nect the brake rod from the brake
camshaft lever.
1. Brake pedal free play adjusting nut
2. Brake camshaft lever
3. Bolt and nut (shoe plate)
4. Brake torque rod
5. Bolt and nut (swingarm)
6. Brake rod
5. Remove panel A. (See page 7-8.)
6. Remove the bolts that secure the
final gear case to the swingarm.
Periodic maintenance and adjustment
1. Bolt
2. Final gear case
7. Lift the rear wheel off the ground
according to the procedure on
page 7-34.
8. While supporting the drive shaft,
pull the rear wheel back to remove
the following parts as an assem-
bly: wheel, wheel axle, final gear
case, and drive shaft.
7-37
1. Drive shaft
TIP
Make sure to support the drive shaft as
it is being pulled out.
To install the rear wheel
1. Install the rear wheel, wheel axle,
final gear case, and drive shaft by
pushing the wheel forward and
guiding the drive shaft into the
middle gear universal joint.
1
7