Denso AT30Q-SM User Manual page 75

(3) Communications parameters for RS-232C interface
The following settings take effect when the RS-232C interface is set up.
Setting
Communication Protocol
Transmission speed
Word length
Parity
Stop bit
CTS signal monitoring
CTS signal monitoring time
ACK/NAK response confirmation
time
RTS Signal Control Procedure
(4) Communications parameters for USB-COM interface
The following settings take effect only when the USB-COM interface is set up.
Setting
Communication Protocol
CTS signal monitoring
CTS signal monitoring time
ACK/NAK response confirmation
time
Remote wake-up
Parameters
Non-acknowledge mode
ACK/NAK mode
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
7 bits
8 bits
Odd
Even
None
1 bit
2 bits
Controlled
Not controlled
0.1 to 9.9 s
0.1 to 9.9 s
Scanner ready mode
Data ready mode
Parameters
Non-acknowledge mode
ACK/NAK mode
Controlled
Not controlled
0.1 to 9.9 s
0.1 to 9.9 s
Enabled
Disabled
65
Default Setting
*
*
*
*
*
*
2 s
1 s
*
Default Setting
*
*
2 s
1 s
*
: Can be changed only with the configuration software.
Refer to:
Section 9.1 (1)
Section 9.1 (3)
Section 9.1 (4)
Section 9.1 (1)
Section 9.1 (1)
Section 9.1 (2)
Refer to:
Section 9.2
Section 9.2
Section 9.2
Section 9.2