Denso AT30Q-SM User Manual page 92

(13) Data verification conditions and data editing conditions
Setting
Data to be verified
Preset master registration
Verification start position
for data string verification
Number of characters to verify
for data string verification
(without preset master registration)
Position of data block to be verified
for data block Verification
Transmission of verification result
for a match
(When verification OK)
When verification result
transmission verification NG
Verification retry after fail
judgment in 2-point verification
Verification range
Applicable codes for data editing
Transmit data regardless of the
results
Data extraction mode
Data string extraction mode Start
position
Data string extraction mode- End
position
Data string extraction mode
Specified position for extraction
start position
Data string extraction mode
Specified position for extraction
last position
Extraction block mode- Extraction
block number (Maximum 3
blocks)
(Note 1) Selecting "Any code" edits all types of codes.
Parameters
Data String Verification
Data Block Verification
Enabled
Disabled
From 001 to 999 digits specify with
ASCII characters
01 to 99 digits in ASCII characters
From 01 to 99 digits specify with ASCII
characters
Disabled
Enabled Code data transmission
OK transmission
Disabled
Enabled Code data transmission
NG transmission
Enabled
Disabled
Code type + code data
Code data only
Specified from the codes
Enable
Disable
Data String Extraction
Data block extraction
AI mode
First character
Last character
Specified position
Last character
Specified no. of digits
Specified position
0001 to 9999 digits in ASCII characters
0001 to 9999 digits in ASCII characters
From 01 to 99 digits specify with ASCII
characters
82
Default Setting
*
*
1
99
1
*
*
*
*
Any code
(Note 1)
*
*
*
*
1
9999
Not
specifi
ed
: Can be changed only with the configuration software.
Refer to:
Section 7.1
Section 7.2