Honda CR250R 2004 Owner's Manual page 64

Clean the threads of the fork protector bolts and axle
holder thoroughly.
Apply locking agent to the bolt threads.
Install the fork protector and tighten the bolts.
TORQUE: 5.1 lbf ft (7 N m, 0.7 kgf
• •
(1) FORK PROTECTOR
Clean the surfaces where the axle and axle clamps
contact each other.
Install the left and right side collars into the wheel hub.
Insert the axle through the wheel hub from the right
side. Make sure the axle is seated firmly onto the left
m) fork leg clamp inner surface. Tighten the axle nut.
•
TORQUE: 65 lbf
(1) AXLE NUT
ft (88 N m, 9.0 kgf m)
• • •
1
Align the brake caliper and hose with the left fork leg,
making sure that the brake hose is not twisted.
Clean the threads of the caliper mounting bolts and
brake caliper thoroughly.
Apply locking agent to the bolt threads.
Install the brake caliper on the fork slider and tighten
the caliper mounting bolts.
TORQUE: 22 lbf ft (30 N m, 3.1 kgf
• •
•
An improperly routed brake hose may rupture and
cause a loss of braking efficiency. Route the hose
carefully.
CAUTION:
•
Fit the brake caliper over the disc, taking care not
to damage the brake pads.
(1) CALIPER (2) CALIPER MOUNTING BOLTS
m)
•
61