Honda CR250R 2004 Owner's Manual page 60

Remove the handlebar holder nuts, washers, rubber
mounts and handlebar.
CAUTION:
•
Keep the master cylinder upright to prevent air
from entering system.
(1) HANDLEBAR HOLDER NUTS/WASHER
(2) RUBBER MOUNTS
(3) HANDLEBAR
Loosen the upper pinch bolts.
Loosen the fork dampers, but do not remove them yet.
CAUTION:
•
Do not use an adjustable wrench to loosen the fork
dampers: it may damage them.
•
loosen the upper pinch bolts before loosening the
fork dampers to avoid damaging the fork caps.
(1) UPPER PINCH BOLTS (2) FORK DAMPER
Remove the disc cover by removing the two bolts.
(1) DISC COVER (2) BOLTS
Remove the axle nut and loosen the axle pinch bolts on
both forks.
Pull the front axle out of the wheel hub and remove the
front wheel.
(1) FRONT AXLE (2) AXLE PINCH BOLTS
(3) AXLE NUT
Remove the fork protector and brake caliper.
CAUTION:
•
Do not support the brake caliper by the brake hose.
•
Do not operate the brake lever after the front wheel
is removed. To do so will cause difficulty in fitting
the brake disc between the brake pads.
1
2
(1) FORK PROTECTOR
Loosen the fork leg lower pinch bolts, then pull the fork
legs down and out.
(3) LOWER PINCH BOLTS
(2) BRAKE CALIPER
57