4. SERVICE AND MAINTENANCE
Cylinder Head Installation
Install the dowel pins.
Install the new cylinder head gasket with its"UP"mark
facing up and locating tab facing rearward.
(1) DOWEL PINS
(2) "UP" MARK/TAB
(3) CYLINDER HEAD GASKET
34
Install the cylinder head and nuts, tighten the nuts to
the specified torque.
TORQUE: 20 lbf
ft (27 N
m, 2.8 kgf
•
•
NOTE:
•
Tighten the cylinder head nuts in a criss-cross
pattern in 2 or 3 steps.
(1) CYLINDER HEAD (2) CYLINDER HEAD NUTS
Install the spark plug and spark plug cap.
Install the hanger plate and tighten the bolts.
m)
TORQUE:
•
Engine side:
Frame side:
Connect the radiator hose to the cylinder head.
Pour the recommended coolant mixture into the radia-
tor up to the correct level (page 21).
(1) RADIATOR HOSE (2) HANGER PLATES
(3) SPARK PLUG
Check for the following:
— compression leaks
— abnormal engine noise
— coolant leaks
NOTE:
•
After installing the radiator hose, check that it is not
interfering with the ignition coil.
40 lbf
ft (54 N
m, 5.5 kgf
m)
•
•
•
20 lbf
ft (26 N
m, 2.7 kgf
m)
•
•
•
(4) CYLINDER HEAD