Installation - Buderus Logano GE315 Installation And Maintenance Instructions Manual

2

Installation

2.6.3 Install the burner door
Installation
Both hinges are fitted at the factory (Fig. 26, [4] & [6]) to
the r.h. side of the burner door. To convert to l.h. hinges,
fit the hinge parts to the l.h. side of the burner door.
Secure each hinge pin (Fig. 26, [1] & [3]) with 2 No.
M 12 x 50 screws on the front section. Fig. 26 shows
this as r.h. closing. Fit the hinge pins to the l.h. side
for l.h. closing.
Stick sealing cord (18 mm dia.) into the front section
using adhesive. Position the butt ends of the gasket
string on the side of the section (Fig. 26, 2).
Hook the burner door with the hinge rings onto the
hinge pins.
2.6.4 Insert the hot gas baffle plates
NOTE!
The hot gas baffles are already fitted if you
receive a pre-assembled boiler block. You
must only remove the protective transport
packing.
Remove the hot gas baffle from the fitting crate and
insert it into the hot gas ways according to the
instructions cast into the baffle body (see Fig. 27
and the following table).
Boiler Number Number of
size of boiler hot gas baffle
in kW sections plates
105 5 4
140/
6 – 7 4
170
200 8 4
230 9 4
22
Length of Fitting
hot gas baffle instructions
plates on the baffle
360
upper r.h.
440
upper l.h.
lower r.h.
360
lower l.h.
200
Logano GE315 - We reserve the right to make any changes due to technical modifications
6
5
Fig. 26 Hooking on the burner door
Fig. 27 Hot gas baffle plates
1
2
3
4