Table of Contents
Advertisement
5．Bezel Module
There are 3 different Bezel Mode A,B and C.
Setting Bezel mode is to be referred with the subject on memory switch.
5- 1．Operating Mode
Bezel Mode
Commonly worked at
Bezel Mode A & B
Bezel Mode A
Bezel Mode B
Bezel Mode C
SK1-21A/31A
The length of printing ticket is set at 60mm. If the length of ticket
(paper) after cutting the paper is specified less than 60mm, the printer
automatically feeds the length to reach 60mm and execute full cut.
Ex) If the setting length is 40mm, the printer feed 20mm more after
printing the data.
If the length of ticket is set beyond 60mm, the ticket length is adjusted
as specified length and cutter mode is changed to partial cut.
Once setting this mode, the printer prints the data on paper
continuously. ESC v and GS a commands is allowed to detect the
information of existing (passing) paper in the bezel through equipped
reflective sensor. But it is not enabled to stop the paper by this
reflective sensor.
This mode is enabled to stop the each ticket (paper).
Whithout taking out the ticket from the bezel, the printer does not print
next ticket. When the printer receives next printing data but nobody
does not take the ticket, such next data are ignored.
ESC v, GS R1 or GS a command is allowed to check the status
of existing paper in the bezel.
This function is basically worked for the same as Bezel Mode-A but
This mode is not performed to adjust the paper length commonly
worked at Mode A/B. The full cut is performed at this mode.
Functions
３８
Hide quick links:
Advertisement
Table of Contents
