4- 5．Memory Switch Setting Menue - SANEI ELECTRIC SK1-21A Technical Manual

4- 5．Memory switch setting menue
（1）COMMON SETTING
Menu Default
PAPER FEED OFF
OFFLINE BUSY ON
SELECT Reflection
SENSOR
MARK OFF
DETECTION
MARK OFF
RE-DETECTION
CHARACTER PC437
TABLE
PRINT 100%
DENSITY
PRINT WIDTH Comply with
classified
paper width
MECHANISM 200mm/s
SPEED
SK1-21A/31A
Value
OFF
ON(10mm) / ON(20mm)
ON(30mm) / ON(40mm)
ON(50mm) / ON(60mm)
ON
OFF
Reflection
Transmission
OFF
ON
OFF
ON
KATAKANA
PC437 / PC850
PC852 / PC857
PC858 / PC863
PC865 / PC866
WPC1252 / PC860
WPC1252_2
PC862 / PC864
WPC1254 / WPC1250
WPC1251 / PC737
80% / 90%
100% / 110%
120% / 130%
140% / 150%
80/72
60/56
58/54
83/80
110mm/s
130mm/s
150mm/s
170mm/s
190mm/s
200mm/s
Description
Enable/disable paper feed after closing the print head.
・ When paper feed is ON, the printer feed the paper as
specified (Xmm) length after closing the print head and
make full-cut after feeding the paper.
・ When paper feed is OFF, the paper is not fed.
・ The value is changeable using the DC2K command.
Enable/disable OFFLINE BUSY when an error occurs.
＜At selecting ON＞
・The communication becomes OFF-LINE when an error
occurs. The printer stops printing and maintained the
receiving data until the error is cleared.
＜At selecting OFF＞
・The communication becomes ON-LINE when an error
occurs. Receiving data during an error are continuously
processed and printing data are not stored.
・ When bezel is used, this mode is selected.
Select the mark sensor for label printing.
・Reflection ･･･ Detected by Black mark sensor
・Transmission･･･ Detected by Gap sensor.
Enable/disable the Black mark sensor/Gap sensor
functions.
Enables/disables re-detecting function after the paper
setting.
Select the characters.
- PC862 font was added after V1.87
- WPCXXXX font was added after V1.68
- PC864 font was added after V1.98
- PC737 font was added after V1.99
Specify the printing density.
Select the paper width.
(Printing width is set at the factory)
Select maximum printing speed
３３