4- 4．Setting The Memory Switch - SANEI ELECTRIC SK1-21A Technical Manual

4- 4．Setting the memory switch
Follow the flow chart to change the parameter. As setting parameter is printed, choose the right
parameter by manipulating the FEED and SELECT buttons.
After completing the parameters set up, data are stored and the printer goes to standby mode.
SK1-21A/31A
■YES : FEED button ------ Decide
■NO : SELECT button ------ Move to next
Function setting mode
ENTER SETTING ?
YES
ENTER COMMON
SETTING ?
YES
Change the setting of COMMON
ＰＡＰＥＲ FEED
ENTER INTERFACE
SETTING ?
YES
Change the setting of INTERFACE
・BAUD RATE
・BIT LENGTH
:
:
YES
MODE END
(Finish)
NO
NO
※ Prints the below after
completing the setting:
SETTING COMPLETE
SETTING MODE END.
※ The setting mode is
finished and the printer goes
to standby mode.
Modified data are stored
automatically.
３２