Interactive Registration - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual

Internet Communication Module 7845i-GSM Installation and Setup Guide
If repeated registration attempts time out, check your Internet connection and RSSI level,
and verify that 7845i-GSM account information has been entered correctly.

Interactive Registration

The interactive registration feature allows the installer to register the 7845i-GSM through a
series of keyboard commands on the 7720P Programming Tool. This method of registration
lets the installer monitor the registration process.
4-2
Registering ...
Registration
SUCCESS
Possible Errors
Registration BAD
Timed Out
Registration BAD
Pri Sub ID BAD
Registration BAD
nd
2 Sub ID BAD
Registration BAD
Pri&Sec – IDs BAD
Registration BAD
Pri ID – Need PIN
Registration BAD
nd
2 ID – Need PIN
Registration BAD
nd
Pri&2 – Need PIN
Once the installation is complete, press the [↑ ↑ ↑ ↑ ] key on
the 7720P. The registration message is sent and the
unit waits for the acknowledgment.
If this is a new installation and the city, central station,
and customer numbers have been correctly entered, the
7845i-GSM is registered and this message is displayed.
The 7845i-GSM is now in full service and available for
alarm reporting to the central station.
Displayed if no response to the registration request is
received.
Indicates the city, central station, or customer number
for the labeled account(s) is not accepted. The ID
information was either entered in error, or the central
station failed to pre-authorize programmed ID numbers
with AlarmNet customer service.
Indicates the city, central station, or customer number
for the Secondary account is not accepted. The ID
information was either entered in error, or the central
station failed to pre-authorize programmed ID numbers
with AlarmNet customer service.
Displayed when both primary and secondary subscriber
IDs are invalid.
Displayed if this is a repair/replacement, or an error was
made in programming the Primary account information
of 7845i-GSM for an existing account. This prompt
appears for 2 seconds. See the Replacing an existing
module section below for further displays.
This prompt is displayed if this is a repair/replacement,
or an error was made in programming the Secondary
account information of 7845i-GSM for an existing
account. This prompt appears for 2 seconds. See the
Replacing an existing module section below for further
displays.
This prompt is displayed if this is a repair/replacement,
or an error was made in programming BOTH the
Primary and Secondary account information of
7845i-GSM for an existing account. This prompt
appears for 2 seconds. See the Replacing an existing
module section below for further displays.