Honeywell AlarmNet 7845i-GSM Installation And Setup Manual page 19

PROMPTS
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)_
Enter Password
6
Verify Password
7
Exit Prog. Mode?
8
(Y/N)_
Device Mode
9
(ECP)_
Important Information Regarding Primary and Secondary Accounts (Questions 10-16)
Account information is provided by the central station administrator. If the control supports
secondary account reporting, you will need secondary account information. The City ID, CS ID or
Subscriber ID of the secondary account must differ from that of the primary account.
Primary City ID
10
(??)_
Primary CS ID
11
(???)
Primary Sub ID
12
(????)
nd
En. 2 CS Y/N
13
(N)_
ENTRY OPTIONS
[Y], [N]
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N]
[ESC]
• ECP
• Zone Triggers
• 4204 Emu
• Two 4204s
[01-99]
[01-FE]
[0001-9999]
[Y], [N]
Section 3: Programming the 7845i-GSM
DESCRIPTION
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
If a password is desired, press [Y] and go to "Enter
Password."
If a password has already been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key when
prompted for the new password and its confirmation.
This prompt is displayed if [Y] was pressed in Prompt
4 or 5.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is displayed
directly.
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph in
this section.
Press the [space] key to scroll through the modes of
operation. Press [ENTER] to select ECP mode.
See Table 5 if programming other modes.
Enter the 2-digit primary city ID, 01-99 (decimal).
Enter the 2-digit primary central station ID number,
01-FE (HEX).
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
Applicable only if control supports secondary reporting.
Used if redundant reporting to a second central station
is desired.
Press [N], go to Prompt 17: "Device Address."
3-3