Replacing An Existing Module Using The Programming Tool - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual

Internet communication
Hide thumbs Also See for AlarmNet 7845i-GSM:
Table of Contents

Advertisement

Replacing an existing module using the programming tool

Enter PIN#
Registering ...
Registration
SUCCESS
Registration BAD
This prompt appears after pressing the down arrow [↓ ↓ ↓ ↓ ]
on the 7720P. Enter a 4-digit alphanumeric PIN number
provided by your central station, your dealer or an
authorized AlarmNet representative.
NOTE: If you are replacing an existing 7845C series
radio, you can enter the last four-digits of the 7845C
MIN number.
Press the [ENTER] key.
The registration message is sent and the unit waits for
acknowledgement.
If the PIN is valid, the new 7845i-GSM is registered and
the old unit unregistered. Additionally, AlarmNet sends
a substitution alarm to the central station.
If you entered an invalid PIN, the appropriate message
is displayed depending on which account number is
being replaced (see above for exact wording). The
registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be
sent to the central station.
Section 4: Registration
4-3

Advertisement

Table of Contents
loading

Table of Contents