Honeywell AlarmNet 7845i-GSM Installation And Setup Manual page 43

Line Voltage
xx.xxV
[T]
Test Msg Sent
[X]
Reset CPU Y/N
[↑ ↑ ↑ ↑ ]
Registering ...
(UP arrow)
[↓ ↓ ↓ ↓ ]
Enter PIN#
(DN arrow)
[0]
Force Server Update?
Y/N
[ENTER]
Strt Prog Mode?
Y/N_
Section 5: Programmer Keyboard Commands
Line Voltage Display
The line voltage of the 7845i-GSM can be viewed on the
7720P. An asterisk (*) next to the voltage indicates that
this is below the accepted level.
Press the [space] key to go back to the System Status
Display.
Press the [backspace] key to go to the previous field.
Test Alarm
Sends a Test alarm to AlarmNet. Functional for a
registered 7845i-GSM only. If the device is not
registered, a message is displayed indicating that the
command cannot be executed.
NOTE: If two CSIP's are used, test alarms are sent to
each central station. In addition, if the primary fails to
report, a second (backup) message is sent to the
secondary station.
Reset the 7845i-GSM.
Pressing [N] returns to normal mode.
Pressing [Y] resets the device.
Registration
Registers a programmed 7845i-GSM with AlarmNet.
Registration with PIN for Replacement Module
Registers a replacement 7845i-GSM with AlarmNet,
once programmed, using the existing PIN #.
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire
configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If the internet is not available, and the 7845i-
GSM module is not initialized when you enter this
command, the following screen will be displayed:
Cannot Upload
Try Later! _
Wait for the RSSI LEDs to light, indicating the
7845i-GSM module has completed its initialization, and
try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].
5-5