Toshiba e-STUDIO166 Service Manual page 75

(C) Misfeed in equipment
• Exit sensor detects jamming of the leading edge of paper.
È
Registration clutch ON
Less than 1.808 sec.
È
Exit sensor ON
If the exit sensor is not turned ON after 1.808
sec.
È
Paper jam (E01) Æ The copying operation is
stopped.
• Exit sensor detects jamming of the tailing edge of paper.
È
Registration clutch OFF
Less than 1.759 sec.
È
Exit sensor OFF
If the exit sensor is not turned OFF after 1.759
sec.
È
Paper jam (E02) Æ The copying operation is
stopped.
• Immediately after the power ON
È
Any of all sensors on paper transport path detects paper (ON)
È
Paper jam (E03)
• Front cover is opened during copying
È
Paper jam (E41)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the feeding starts.
È
Paper jam (E12, E13 and E21: Error code differs depending on the paper source.) Refer to the
error code table in Service Handbook.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Registration clutch
Exit sensor
Timer
Fig. 4-1
Registration clutch
Exit sensor
Timer
Fig. 4-2
4 - 7
ON
ON
0
1.808sec.
Paper jam (E01)
OFF
ON
0
1.759sec.
Paper jam (E02)
e-STUDIO166/206
GENERAL OPERATION
4