Toshiba e-STUDIO166 Service Manual page 65

8) Fusing
Fusing is the process of melting the toner on the paper and fixing it firmly on the paper.
Method: The melting point of the toner (main ingredi-
ent: resin) is 90-100°C.
(Heat) Toner is melted by the heat of the surface of
the fuser roller.
(Pressure) The pressure roller is pressed against the
fuser roller by the springs to increase the
adherence of the melted toner onto the
paper.
Heat and pressure are applied to the paper
when it passes between the fuser roller and
pressure roller.
(Fusing) The toner is fused on the paper.
9) Cleaning
Cleaning is the process of removing the residual toner from the photoconductive drum.
The edge of the urethane rubber cleaning blade is pressed against the photoconductive drum sur-
face to scrape off the residual toner on it. The toner is then caught by the recovery blade.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
È
+
È
È
Cleaning blade
Drum rotation
Fig. 3-21
3 - 11
Fuser roller
Paper
Fig. 3-19
Separation finger
Fuser roller
Heater lamp
Paper
movement
Fig. 3-20
Recovery blade
Pressure
( Pressure )
Pressure roller
e-STUDIO166/206
COPY PROCESS
3