Toshiba e-STUDIO166 Service Manual page 221

[G] Fuser roller
(1) Take off the center heater lamp and the side
heater lamp.
P.13-16 "[F] Center heater lamp / Side
heater lamp (LAMP1/LAMP2)"
(2) Take off the separation fingers.
P.13-15 "[E] Separation finger"
(3) Take out the fuser roller upward.
Notes:
• When installing the fuser roller, slide each
bushing on both edges of the roller out-
ward so that the bushings will engage
with the frame and the installation will be
secured.
• Do not apply force onto the roller because
it may be deformed.
(4) Remove 1 C-ring and 1 bushing on the front
side of the fuser roller.
(5) Remove 1 C-ring, 1 gear and 1 bushing on
the rear side of the fuser roller.
[H] Pressure roller
(1) Take off the pressure roller unit.
P.13-11 "[B] Pressure roller unit / Fuser
roller unit"
(2) Remove 3 screws, and then take off the
fuser unit entrance guide.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 13-24
Bushing
C-ring
Fig. 13-25
Fuser unit entrance guide
Fig. 13-26
13 - 17
Fuser roller
C-ring
Gear
Bushing
e-STUDIO166/206
FUSER / EXIT UNIT
13