Toshiba e-STUDIO166 Service Manual page 156

Note:
When assembling the drawer pickup clutch,
adjust the position of the hook of the spring
and the covers so that the stopper of the
cover-B and the center of the rib of the
cover-A are aligned.
[P] Registration roller (rubber)
(1) Take off the transfer/separation charger.
P.11-16 "[L] Transfer/Separation charger"
(2) Remove 1 clip and take off 1 gear and the
registration roller (rubber) while sliding them
to the front side.
(3) Remove 2 washers, 1 E-ring, 1 gear, and 1
pin from the registration roller.
e-STUDIO166/206
PAPER FEEDING SYSTEM
Rib
Registration roller (rubber)
Clip
Washer
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
10 - 24
Cover-B
Slit
Cover-A
Stopper
Fig. 10-44
Fig. 10-45
Washer
Gear
Pin
Registration roller (rubber)
Fig. 10-46
E-ring