Keil Sdk; Introduction; Install Vision3; Install The Driver For The Jtag Adapter - STMicroelectronics STM32 Cortex-M3 Manual

3 Keil SDK

3.1 Introduction

The development of the firmware
Keil. This chapter shows how a simple project can be created, simulated and downloaded to the
target hardware.

3.2 Install Vision3

Vision3 can be found on the CD delivered with this documentation. Install Vision3 as well the
demo projects. This documentation refers to a standard installation done in the folder
C:/Keil/ARM/Boards/ST/STM32F10X EVAL/
A quick guide about Vision3 can be found at www.keil.com.

3.3 Install the Driver for the JTAG Adapter

Install the driver according the JTAG Adapter you are using.

3.4 Install the STM32 Peripheral Library

ST offers a free ARM-based 32-bit MCU STM32F10xxx standard peripheral library for program-
mers. This can be downloaded from www.st.com.
Direct Link: STM32F10x StdPeriph Lib
This library is used for accessing the peripherals like SPI or CAN. The STM32 Peripheral Library
from ST comes as well with different examples.
Unpack the library and copy the
C:/Keil/ARM/INC/ST/STM32F10x
C:/Keil/ARM/INC/RV31/LIB/ST/STM32F10x/
libraries.
Keil offers as well a peripheral configuration wizard but not for all peripherals. Chapter
troduces the peripherals and shows how they are configured - ether by the configuration wizard
from Keil or using the libraries from ST.
1
Software for microcontroller
1
we will write for the STM32 is done with the Vision3 from
.
/Libraries/STM32F10x StdPeriph Driver/inc/
and
/Libraries/STM32F10x StdPeriph Driver/src
. This has to be done only once to update the
to
to
4 in-
13