Cisco Aironet 1520 Series Mounting Instructions page 61

Table 4
Label Marking
AEx nA II T5
Ex nA II T5
-40 < Ta < 55C
Type 4, IP66
CSA Certificate 1945576
Mounting the Access Point
You can mount the access point using any of the mounting systems described in this document. Follow
the instructions in the appropriate section or sections for the installation you intend to use.
Routing and Connecting Ground, AC Power, and Ethernet Backhaul Cables
After you have mounted the access point, you must route ground, AC power, and backhaul Ethernet
cabling to the access point using rigid steel conduit.
When you install the conduit, be sure to comply with the local electrical codes for your area.
Note
The procedure is divided into five parts:
1.
2.
3.
4.
5.
We recommend that you follow these steps in the sequence listed. Before you begin, you should refer to
Figure 40
installation details.
78-18269-04
Interpreting the Hazardous Compliance Label (continued)
"Installing the PG-13 1/2 NPT Conduit Adapters" section on page 63
"Opening the Access Point Hinged Cover" section on page 64
"Connecting Ground and AC Power" section on page 65
"Closing the Access Point Hinged Cover" section on page 66
"Connecting the Ethernet Backhaul Cable" section on page 67
for AC power and ground installation details and to
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
Installing the Access Point in Hazardous Locations
Description
Defines parameters that the product complies with for U.S.
Certification:
Ex—Denote explosive atmosphere
•
nA—Non-sparking
•
II—group II as defined previously
•
T5—Temperature code < 100 degrees C, maximum surface
•
temperature
This marking is the same as AEx line except it is for the Canada
certification.
The operating temperature range for the access point in all
countries.
Defines the enclosure's degree of protection (Type 4 = indoor or
outdoor use primarily to provide a degree of protection against
windblown dust and rain, splashing water, hose-directed water, and
damage from external ice formation. IP66 = Dust tight, protected
against powerful water jets.
CSA certification number
Figure 41 for Ethernet backhaul
61