Cisco Aironet 1520 Series Mounting Instructions page 36

Mounting the Access Point
Continue with the
Step 7
Point" section on page
Opening the Access Point Hinged Cover
You need to open the access point hinged cover when you are performing these operations:
•
•
To open the access point hinged cover, follow these steps:
Use 0.5-in. (13-mm) box-end wrench or socket set to unscrew the six bolts on the front cover of the unit.
Step 1
Only unscrew the bolts about 2 turns until they are easily turned by hand, do not remove the bolts.
The cover is hinged on the bottom. Carefully open the cover and swing it down.
Step 2
Note
Figure 23
1
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
36
"Grounding the Access Point" section on page 39
43.
Installing a cable POC Stinger connector
Installing fiber-optic SFP module and fiber cable take-up reels
If the cover does not swing open easily, carefully loosen the hinge bolts again.
Access Point Front View
M8 x32 bolts
and the "Powering the Access
2 Cover hinge M8 x32 bolts
78-18269-04