Cisco Aironet 1520 Series Mounting Instructions page 56

Powering the Access Point
Locate the stinger set-screw on the RF splitter (see
Step 7
Figure 37
1 RF splitter attenuator
2 Cable connector plug
3
Stinger set-screw
Use a Phillips screw driver, and loosen, but be careful not to remove the set-screw.
Step 8
Cut the cable stinger connector's pin (see
Step 9
Figure 38
1 Pin length is 0.75 + 0.1in. (1.91 + 0.25 cm).
Step 10 Insert the cable Stinger connector pin into the cable POC connector opening in the access point case.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
56
Stinger Connector Location and RF Splitter Components
Figure
Cable Stinger Connector Pin
Figure 37).
4 RF splitter shunt
5 RF splitter
6
Cable modem
38) to 0.75 + 0.1 in. (1.91 + 0.25 cm).
78-18269-04