Cisco Aironet 1520 Series Mounting Instructions page 26

Mounting the Access Point
Tighten the metal bands using the banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=),
Step 5
following the operating instructions in the box with the tool. Ensure the metal bands are as tight as
possible.
Place the mounting bracket onto the pole clamp bracket support bolt (see
Step 6
Step 7 For vertical poles, position the mounting bracket as shown in
rotate the mounting bracket 90
Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.
Step 8
Figure 13
1 Pole clamp bracket assembly
2 Access point support bolt
(M8 flange nut not shown)
Step 9 Hand-tighten the bolts and the nut (do not overtighten).
Step 10 Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
(see Figure
Note
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
26
o
from the position shown in
Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly
13) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
The mounting bracket can be adjusted up to 45
poles.
Figure
Figure 13. For horizontal streetlight poles,
Figure 13.
3 Bolt holes
4 Mounting bracket
o
to compensate for tilted horizontal streetlight
13).
78-18269-04