Cisco Aironet 1520 Series Mounting Instructions page 46

Powering the Access Point
Install an RJ-45 connector on the unterminated end of the Ethernet cable using your Ethernet cable
Step 6
installation tool.
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023
Warning
Carefully insert the RJ-45 cable connector into the Ethernet port opening on the access point, and
Step 7
connect to the internal Ethernet connector (see
Figure 30
1
Liquid tight adapter
2 Ethernet port opening in access point case
Slide the liquid tight adapter towards the access point, and screw the threaded end of the adapter into the
Step 8
access point, and hand-tighten.
Use an adjustable wrench, a 22 mm socket, or a Sealcon S-2200-WR wrench to tighten the threaded end
Step 9
of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).
Use an adjustable wrench and tighten the round end of the adapter to 2.7 to 3.2 ft lbs (3.66 to 4.34 Nm).
Step 10
Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 11
Route your Ethernet cable, and cut off any excess cable.
Step 12
Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical
Step 13
installation components see
Turn on power to the power injector.
Step 14
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
46
Inserting RJ-45 Connector into the Ethernet Port Opening in Case
Figure 2.
Figure 30).
3
RJ-45 connector
4 Shielded outdoor-rated Ethernet (CAT5e or
better) cable
78-18269-04