the original status if there is no input for 10 seconds.
| C onnecting fitting
The specification of the DigiFlow
8000T connectors is 3 /8 " NPT
fem ale. You could use any 3/8"
NPT male connectors.
| O perating
The D igiFlow 8000T will be autom atically on when there
is any water flow ing through the sensor. It will a utom ati
cally off when there is no water flow ing for 10 seconds .
DISPLAY
button:
Press DISPLAY
three modes of the DigiFlow 8000T. show ing the ca pa ci
ty left. Tim ing m ode:show ing the tiniing left.Flow rate
m ode:show ing the current flow rate. The sequence is
Flow -R ate-Tim ing-C apacity...
RESET button:
Press
RESET button is to reset the setting to be the last
setting-
| button is to display the status of the
g/m