Owner's Manual – Viscount CantorumVI
1.1 LOOKING AFTER THE PRODUCT
Do not apply excessive force to the product's structures or the controls (knobs, connectors,
•
push-buttons, etc.).
When possible, do not place the instrument close to units which generate strong
•
interference, such as radios, TVs, computer videos, etc.
Do not place the product close to heat sources, in damp or dusty places or in the vicinity of
•
strong magnetic fields.
Do not expose the product to direct sunlight.
•
Never insert foreign bodies inside the product or pour liquids of any kind into it.
•
For cleaning, use only a soft brush or compressed air; never use detergents, solvents or
•
alcohol.
Always use good quality screened cables for connection to amplification or diffusion
•
systems. When disconnecting cables from sockets, always take hold of the connector and
not the cable itself; when winding cables, do not knot or twist them.
Before making the connections ensure that the other units (especially amplification and
•
diffusion systems) you are about to connect are switched off. This will prevent noisy or even
dangerous signal peaks.
Connect the net cable to an earthed socket.
•
Check that the voltage corresponds to the voltage shown on the serial number plate of the
•
product.
If the product is to be out of use for lengthy periods, disconnect the plug from the power
•
socket.
1.2 NOTES ABOUT THE MANUAL
Take good care of this manual.
•
This manual is an integral part of the product. The descriptions and illustrations in this
•
publication are not binding.
1.IMPORTANT NOTES
EN - 2