Transmission Of Program Change; Demo Songs - Viscount Cantorum VI Owner's Manual

Owner's Manual – Viscount CantorumVI
state of the Local Off for the selected section: "0" if it is disabled, "1" if it is enabled. To modify the
status of that section, press one of the two LEDs "0" or "1". The "PG" LED will flasg 5 times to
indicate that the new status was set successfully and the LED of the modified section will stop
flashing. To exit the Local Off setup mode, press again the section you previously selected.

TRANSMISSION OF PROGRAM CHANGE

For each of the 12 memories you can associate a Program Change number and enable the
transmission of the relative MIDI message each time you recall a memory.
To transmit and enable the transmission of Program Changes first enter the MIDI mode by pressing
for about two seconds [TRANSPOSER]. Then enter the Program Change selection modality
turning on the first stop of Manual I (labelled PG). Then, pressing the memory buttons (if necessary
press the [BANK] button to switch from memories 1-6 of Bank A to memories 1-6 of Bank B), the
stops of manual I and manual II will blink in sequence to show the actual Program Change number
(numbers 0 to 9 are written under the stops of manual I and manual II; for example: if pressing the
memory button [1], the stop labelled "0" blinks twice and then the stop with label "1" once,
indicating that the Program Change number associated to the memory button [1] is "001").
Meanwhile the Program Change number will be sent via MIDI.
Now you can enter a new Program Change number for the memory selected: press the stops
corresponding to the number you want to enter.
Every number is made of 3 figures (so, for example to input the Program Change number nine you
have to press, in the order: "0", "0", "9").
To exit from the Program Change mode press [TRANSPOSER].
Note: If MIDI messages transmission has been disabled in every section, Program Changes (as other
messages) won't be sent.

4.6 DEMO SONGS

There are six Demo songs to evaluate and appreciate at best the sound of the instrument. To play
Demo songs press for about two seconds the [BANK] button, then choose one of the songs by
pressing one of the memory buttons (buttons [1] to [6]).
Press again [BANK] to exit from Demo mode.
EN - 15