Clevo P650HS Service Manual page 39

4. Gently pull the two release latches (
arrows (Figure 7c). The RAM module
5. Pull the latches to release the second module if necessary.
6. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
7. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
as it will go. DO NOT FORCE IT; it should fit without much pressure.
8. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
c.
7
8
& ) on the sides of the memory socket in the direction indicated by the
7
8
will pop-up ( Figure 7d
9
d.
7
8
) , and you can then remove it
.
9 9
Removing the System Memory (RAM) 2 - 11
Disassembly
Figure 7
RAM-1 Module
Removal (cont'd)
c. Pull the release lat-
ches.
d. Remove the module.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module's performance.

9. RAM Module