Clevo P650HS Service Manual page 37

4. Slightly lift and pull the hard disk in the direction of arrow
5. Lift the hard disk assembly
-
6. Remove screws and bracket
8 15
7. Reverse the process to install a new hard disk (do not forget to replace the screws).
c.
5
Installing 9.5mm or 7mm HDD
Note that the hard disks pictured on the following pages are all
7mm(h) hard disk drive.
In some cases 9.5mm(h) hard disk drives will be installed. It can only
be installed on the upper slot.
There are two hard disk drive options:
Two changeable 2.5" (6cm) 7.0mm (h) SATA (Serial) Hard Disk
Drives/Solid State Drives (SSD) supporting RAID level 0/1
Or
One changeable 2.5" (6cm) 9.5mm (h) SATA (Serial) Hard Disk
Drive/Solid State Drive (SSD)
For more information, contact your distributor/supplier, and bear in
mind your warranty terms.
(Figure 5c
5
out of the bay (Figure 5d ).
6
7
from the hard disk
16
d.

).
)
(Figure 5e .
17
6
8
e.
12
16
11
15
10
14
17
17
Disassembly
Figure 5
HDD Assembly
Removal (cont'd.)
c. Slightly lift and pull the
HDD in the direction of
the arrow.
d. Lift the HDD assembly
out of the bay.
e. Remove the screws and
bracket from the HDD.
7
9
13

6. HDD Assembly
16. HDD Bracket
17. HDD
• 8 Screws
Removing the Hard Disk Drive 2 - 9