Set Time And Date; Display Accumulator - Rice Lake 880 Technical And Service Manual

Setpoint Value and Preact Value may be accessible from the front panel in weigh mode.
Note
Some indicator configurations may not allow setpoint values to be changed through the front panel or may
require a password to display or change the setpoint value.
Turn Setpoint On or Off
To turn a setpoint off at the front panel:
. AUDIT is displayed.
MENU
1. Press
until SETPTS is displayed.
2. Press or
3. Press and the first available setpoint number is displayed.
4. Press or to toggle through each setpoint that is operator accessible.
5. Press , then press
6. Press , then press
TARE
7. Press to accept the setting.
MENU
8. Press to return to weighing mode.
Some indicator configurations may not allow setpoints to be turned off through the front panel or may require
Note
a password to turn the setpoint on and off.

1.4.10 Set Time and Date

, AUDIT is displayed.
MENU
1. Press
until T&D is displayed.
2. Press or
3. Press , TIME is displayed.
4. Press , to enter time.
5. To edit the value ( 24 hour format):
• Press or to select the digit.
• Press or to increment or decrement the value.
when the value is correct. DATE is displayed.
TARE
6. Press
7. Press , to enter time.
8. To edit the value in specified format (MMDDYY, DDMMYY, or YYMMDD):
• Press or to select the digit.
• Press or to increment or decrement the value.
when the value is correct. TIME is displayed.
TARE
9. Press
MENU
10. Press to return to weighing mode.

1.4.11 Display Accumulator

The accumulator must be enabled before use in either normal mode or setpoint operations. Once enabled, weight
(net weight if a tare is in the system) is accumulated whenever a print operation is performed using the
digital input, setpoint PSHACC operation or serial command. The scale must return to below the threshold value
(except for the setpoint PSHACC operation) before the next accumulation.
to enter the user setup mode, AUDIT is displayed.
MENU
1. Press
until ACCUM is displayed.
2. Press or
Note
ACCUM
is only displayed if the accumulator is enabled.
3. Press , VIEW is displayed.
or to
ENABLE/DISABLE
or to turn setpoint
ON/OFF
.
.
key,
PRINT
Introduction 7