Commodore PC Ms-Dos 3.2 User's Manual page 379

S—7 307
Target diskette may be unusable
[Diskcopy]
/^ ■ Either the target disk has an unrecognizable format, or it is
bad.
Try to format the disk with the format command, or run
(~*\ chkdsk on it to determine the problem.
Target is a floppy (or hard) disk
-. [Backup]
> ' ■ This is an informational message only.
Target is full
f0**} [Restore]
■ There is no more room on the target disk for restored files.
You must delete some of the files on the disk to make room for
/-*^ these files, or use another disk.
Target is Non-Removable
[Restore]
/ i ■ This is an informational message only.
Terminate batch job (Y/N)?
/^ [MS-DOS]
■ Ifyou press control -c while in batch mode, msdos asks you
whether or not you wish to end batch processing
f\ Press Y (for Yes) to end processing, or AT (for No) to continue.
The last file was not restored
[Restore]
C*^ ■ There was not enough room on the target disk for the file, or
the last file was bad
Use the chkdsk command to determine the problem.
Too many files open
[Edlin][Label]
~^ ■ msdos could not open the .bak file or write the volume label
' due to the lack of available system file handles.
Increase the value of the files command in the config.sys file.
f0*} Too many open files
[Backup][FC][Restore][Xcopy]
■ msdos could not open the files that you want to compare due
^-^ to the lack of available system file handles.
Increase the value of the files command in the configsys file.