Commodore PC Ms-Dos 3.2 User's Manual page 359

F287|
First cluster number is invalid,
entry truncated
^~ [Chkdsk]
' > ■ The file directory entry contains an invalid pointer to the data
area Ifyou specified the /f switch, the file is truncated to a
zero-length file.
FIRST diskette bad or incompatible
[Diskcomp]
/-■n ■ Diskcomp cannot recognize the format on the source disk.
You should run chkdsk to help you identify the problem.
Fixups needed - base segment hex:
fi [Exe2bin]
■ The source (.cxc) file contained information indicating that a
load segment is required for the file.
f0*^ You must specify the absolute segment address where the fin
ished module is to be located.
^-v For cannot be nested
' [MS-DOS]
■ You cannot nest For commands in a batch file.
O Format another (Y/N)?
[Format]
■ Format displays this message when it has finished formatting
(~*\ a disk
Type Y (for Yes) if you want to format another disk, or type TV
(for No) if you don't. If you accidentally type y, you can abort
/-—\ the format process by typing control-c in response to the mes
sage "Strike any key."
Format complete
(] [Format]
■ Format displays this message when it has finished formatting
the disk in the specified drive.
Format failure
[Format]
^^ ■ ms-dos could not format the disk This message is usually
f? displayed with an explanation as to why the command failed
Format not supported on drive x:
f^\ [Format]
■ You cannot use Format to format this drive.
You may have specified device parameters that your computer
/*—s cannot support.