Commodore PC Ms-Dos 3.2 User's Manual page 373

N—P301
Parameters not compatible with fixed disk
^-k. [Format]
' ' ■ Fow ##t>e wmf a switch that is not compatible with the speci
fied drive.
f~\ Parameters not supported
[MS-DOs][Format]
■ You have specified parameters that ms DOS does not support.
^ Parameters not supported by Drive
[Format]
^^^ ■ Format displays this message when the device driver for this
i) drive does not support Generic IOCTL function requests.
Path(name) too long
f-*\ [Print ][Replace][Xcopy]
■ The pathname you specified was too long.
You may have to change directories to use this command with
-—*v files in deep subdirectories.
Path not found
[Chkdsk][Replace][Subst][Xcopy]
r**\ ■ You specified an invalid pathname.
Press any key to begin adding (replacing) file(s)
s~K [Replace]
( ■ When you specify the /w switch, Replace displays this message
to prompt you to start replacing files.
f0^ Press any key to begin formatting x:
[Format]
■ This prompt is issued before you format a disk
^""^ Press any key to begin the format process. Or, if you wish to
end this command, press control-c.
/—^ Press any key to begin recovery of the
< ^ n file(s) on drive x:
[Recover]
■ This prompt is issued before you recover a disk or file.
C**) Press any key to begin the recovery. Recovered files are named
filennnn.rec. If you wish to end this command, press control-c.
/-^ Press any key when ready ...
[Diskcomp][Diskcopy]
■ This prompt gives you time to insert the appropriate disks
**+. before copying them.
' When you have inserted the disks into the appropriate drives,
press any key to begin the diskcopy process. Or, if you wish to
^.^^ end this command, press control-c.