Commodore PC Ms-Dos 3.2 User's Manual page 367

/—L295
Invalid time
I f~\ [Time]
■ You specified an invalid time.
Refer to Chapter 3, "ms-dos Commands," for the correct syntax,
^. and try the command again.
Invalid Volume ID
[Format]
f^ ■ Format displays this message ifyou enter a volume label that
doesn't match the label on the hard disk you want to format.
It then quits the format process.
f*^ Use the vol command to find out what the volume label for the
hard disk is, then try the command again.
Label not found
f) [MS-DOS]
■ Your batch file contains a Goto command to a nonexistent
label.
Last backup diskette not inserted
Insert last backup diskette in drive x:
^~. Strike any key when ready
f " [Backup]
■ This message prompts you for the final backup disk
^^ After you have put the final backup disk into the drive speci
fy ) fied, press any alphanumeric key to continue the backup
process.
(~\ *** Last file not backed up ***
[Backup]
■ Backup could not back up the last file on the disk This mes-
s-*^ sage may occur if there is no more room on the target disk. It
' ' may also occur if there was an error in the source file, or on
the target disk
^^ You may have to back up this file separately to another disk.
Line too long
[Edlin]
f0^ ■ During an Edlin R (replace) command, the string given as the
replacement caused the line to expand beyond the limit of
253 characters.
/*—\ You should divide the long line into two lines and retry the R
command.