Commodore PC Ms-Dos 3.2 User's Manual page 353

D281
Do not specify filename(s)
Command format: DISKCOPY d: d:[/1]
>-N [Diskcopy]
' ■ You specified an incorrect switch or gave a filename in addi
tion to a drive name.
(~*\ DOS 2.0 or later required
[Attrib][Backup][FC][Graphics][Join][Mode][Restore][Subst]
■ You cannot use these utilities with l.xx versions ofMS-DOS.
** Do you see the leftmost 0? (Y/N)
[Mode]
^. ■ Mode displays this message to help you align the test pattern
(i on your screen •
Type F(for Yes) if you can see the leftmost 0 in the test pat
tern, or type TV (for No) if you want to shift the display to the
O right.
Do you see the rightmost 9? (Y/N)
^ [Mode]
■ Mode displays this message to help you align the test pattern
on your screen.
>-^ Type Y (for Yes) if you can see the rightmost 9 in the test pat-
' ' tern, or type AT (for No) if you want to shift the display to the
left.
f0**) Drive letter must be specified
[Format]
■ You did not specify the drive letter for the drive that you want
/*—^ to format.
You must specify the name of the drive that you want to for
mat.
f) Drive x: not ready
Make sure a diskette is inserted into
the drive and the door is closed
(~*) [Diskcomp][Diskcopy]
■ The drive is empty, or you did not close the door of the disk
drive.
Drive types or diskette types
not compatible
^^ [Diskcomp][Diskcopy]
fi ■ You must have the same size and type of disks to run these
commands. For example, you cannot copy from a single-sided
disk to a double-sided disk, or compare a high-density disk
(***) with a low-density disk.
n