Commodore PC Ms-Dos 3.2 User's Manual page 378

1306 Appendix E MS-DOS Message Directory
Specified MS-DOS search directory bad ^
[MS-DOS]
■ The Shell command in the config.sys/i/e is incorrect ,
Make sure that the command.com file exists and that ms-dos ^—^
can find it.
Strike a key when ready... l^J
[MS-DOS]
■ This prompt occurs during command processing and is always
accompanied by another message. This message is also ( \
displayed ifyou have inserted a Pause command in a batch ^~"^
file. Usually, ms-dos asks you to insert disks into appropriate
drives before this prompt. , ■
To begin command processing, press any character, any number ^—'
key, the spacebar, or the return key.
Syntax error {K_J
[Attrib][Find][MS-DOS]
■ You have entered a command incorrectly.
Check to make sure you have typed the command correctly. I }
Remember to enclose the find command string in double
quotation marks.
System transferred ^J
[Format ][Sys]
■ The system files were transferred during Format or Sys com
mand processing. K^J
Target cannot be used for backup
[Backup] , .
■ Either the target disk has an unrecognizable format, or it is Vw/
bad
Do not use the disk, or try to format the disk with the format * v
command, or run chkdsk on it to determine the problem. \w/
Target disk is Non-removable
[Backup] \^J
■ This is an informational message that the target disk is a hard
disk
Target diskette is write protected w'
[Diskcopy]
■ The target disk either has a unite-protect tab on it, or it does
not have a ivrite-protect notch. i^^i
If you want to destroy any existing information on the disk,
remove the write-protect tab and give the command again. If
the disk does not have a write-protect notch, you cannot use it M
as a target disk.
U