Bovie Aaron 1250 User Manual page 47

The A1250™ is intended for use in the electromagnetic environment listed below. The customer or the user
of the A1250™ should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power supply
input lines
IEC 61000-4-11
Power frequency (50/60
Hz) magnetic field
IEC 61000-4-8
NOTE U t is the a.c. mains voltage prior to application of the test level.
A-6
Guidance and manufacturer's declaration – electromagnetic immunity
IEC 60601
test level
±6 kV contact
±8 kV air
±2 kV for power
supply lines
±1 kV for
input/output lines
±1 kV differential
mode
±2 kV common
mode
<5 % U t
(>95 % dip in U )
t
for 0.5 cycle
40 % U t
(60 % dip in U )
t
for 5 cycles
70 % U t
(30 % dip in U )
t
for 25 cycles
<5 % U t
(>95 % dip in U )
t
for 5 sec
3 A/m
Compliance level Electromagnetic environment - guidance
Floors should be wood, concrete
or ceramic tile. If floors are
±6 kV contact
covered with synthetic material,
±8 kV air
the relative humidity should be at
least 30%.
±2 kV for power
Mains power quality should be that
supply lines
of a typical commercial or hospital
±1 kV for input/out-
environment.
put lines
±1 kV differential Mains power quality should be that
mode of a typical commercial or hospital
±2 kV common environment.
<5 % U t
(>95 % dip in U )
t
for 0.5 cycle
Mains power quality should be that
of a typical commercial or hospital
40 % U t
environment. If the user of the
(60 % dip in U ) for
t
A1250™ requires continued
5 cycles
operation during power mains
70 % U t
interruptions, it is recommended
(30 % dip in U ) for
that the A1250™ be powered from
t
an uninterruptible power supply or
25 cycles
a battery.
<5 % U t
(>95 % dip in U )
t
for 5 sec
Power frequency magnetic fields
should be at levels characteristic
3 A/m of a typical location in a typical
commercial or hospital
environment.
Bovie Medical Corporation