Figure 73: Contents Of The Shipping Crate - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide

Figure 73: Contents of the Shipping Crate

156
NOTE: The services gateway is maximally protected inside the shipping crate.
Do not unpack it until you are ready to begin installation.
To unpack the services gateway, follow these steps (see
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate cover and set it aside.
4.
Slide the remainder of the shipping crate cover off the pallet.
5.
Remove the foam covering the top of the services gateway.
6.
Remove the accessory box and the SRX5800 Services Gateway Getting Started Guide.
7.
Verify the parts received as described in
8.
Parts Received" on page
Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being careful
9.
not to break the VCI packs open.
To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket wrench
10.
and a number 2 Phillips screwdriver to remove the bolts and screws from the brackets.
Store the brackets and bolts inside the accessory box.
11.
Save the shipping crate cover, pallet, and packing materials in case you need to move
12.
or ship the services gateway at a later time.
"Verifying the SRX5800 Services Gateway
157.
Figure 73 on page 156):
Copyright © 2015, Juniper Networks, Inc.