Cessna T182 1982 Pilot Operating Handbook page 240

30
CESSNA 400 TRANSPONDER PILOT'S OPERATING HANDBOOK
AND ENCODING ALTIMETER SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane limitations when this avionic
equipment is installed. However, the encoding altimeter used in this
'installation does have a limitation that requires a standard barometric
altimeter be installed as a back-up altimeter.
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
1.
Function Selector Switch -- ON.
2. Reply-Code Selector Switches -- SELECT 7700 operating code.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
COMMUNICATIONS (WHEN IN A CONTROLLED ENVIRONMENT):
1.
Function Selector Switch -- ON.
2. Reply-Code Selector Switches - - SELECT 7700 operating code for 1
minute; then SELECT 7600 operating code for 15 minutes and then
REPEAT this procedure at same intervals for remainder of flight.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKEOFF:
1.
Function Selector Switch -- SBY.
TO TRANSMIT MODE A (AIRCRAFT IDENTIFICATION) CODES IN
FLIGHT:
1.
Reply-Code Selector Switches -- SELECT assigned code.
21 August 1981
4