Cessna T182 1982 Pilot Operating Handbook page 234

29
CESSNA 400 TRANSPONDER PILOT'S OPERATING HANDBOOK
AND ALTITUDE ENCODER (BLIND) SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane limitations when this avionic
equipment is installed. However, the following information must be
displayed in the form of a placard located near the altimeter.
I
I
ALTITUDE ENCODER EQUIPPED
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
1.
Function Selector Switch -- ON.
2. Reply-Code Selector Switches -- SELECT 7700 operating code.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
COMMUNICATIONS (WHEN IN A CONTROLLED ENVIRONMENT):
1.
Function Selector Switch -- ON.
2. Reply-Code Selector Switches -- SELECT 7700 operating code for 1
minute; then SELECT 7600 operating code for 15 minutes and then
REPEAT this procedure at same intervals for remainder of flight.
21 August 1981
4