Cessna T182 1982 Pilot Operating Handbook page 227

19
CESSNA 300A AUTOPILOT PILOTS OPERATING HANDBOOK
(TYPE AF-395A) SUPPLEMENT
15. ACTUATOR - The torque motor in the actuator causes the ailerons to move in the
commanded direction.
16. NAV SWITCH - Selects NAV lor NAV 2 navigation receiver.
17. PULL TURN KNOB - When pulled out and centered in detent, airplane
will
fly
wings-level; when turned to the right (R), the airplane will execute a right,
standard rate turn; when turned to the left (L), the airplane will execute a left,
standard rate turn. When centered in detent and pushed in, the operating mode
selected by a pushbutton is engaged.
18. TRIM - Used to trim autopilot to compensate for minor variations in aircraft trim
or lateral weight distribution. (For proper operation, the aircraft's rudder trim, if
so equipped, must be manually trimmed before the autopilot is engaged.)
19. AlP SWITCH - Turns autopilot ON or OFF.
Figure 1. Cessna 300A Autopilot, Operating Controls and Indicators
(Sheet 3 of 3)
21 August 1981
4