Cessna T182 1982 Pilot Operating Handbook page 201

3
PILOTS OPERATING HANDBOOK
SUPPLEMENT
Minutes
Timer
Mode
Indicator
RST
DT JAV
MODE
0
STjSP
0
DIGITAL CLOCK
MODEL T182
Seconds
59 min.
then min.
digits)
Digits
(Until
59 min.
59 sec.
then
hours
digits)
Digits
(Until
59 sec.
DTjAV
MODE
0
RST
ST jSP
0
LH Button: Sets date and LH Button: Resets timer to
time of day (when used "zero".
with RH button).
Center Button: Alternately
Center Button: Alternately
displays clock or timer status displays clock or timer status
RH Button: Shows calendar RH Button: Alternately starts
date momentarily; display and stops timer; timer starts
returns to clock mode after from any previously accumu­
1.5 seconds. lated total.
Figure 2. Clock Mode
Figure 3. Timer Mode
SETTING CORRECT DATE AND TIME
The correct date and time are set while in the clock mode using the LH
and RH push buttons as follows; press the LH button once to cause the date
to appear with the month flashing. Press the RH button to cause the month
to advance at one per second (holding button), or one per push until the
correct month appears. Push the LH button again to cause the day of month
to appear flashing, then advance as before using RH button until correct
day of month appears.
Once set correctly, the date advances automatically at midnight each
day. February 29 of each leap year is not programmed into the calendar
mode, and the date will advance to March
1.
This may be corrected the
following day by resetting the mode back to March
1.
21 August 1981
3